Hero Cover

Ipamorelin

A selective growth hormone–releasing peptide that increases GH naturally without major side effects.

Quickstart Highlights

Ipamorelin 5mg dosage protocol aims to support growth hormone release and assist in muscle recovery through once- or twice-daily subcutaneous injections.

  • Typical starting dose between 300 – 500 mcg per injection

  • 1–2 daily injections for flexible scheduling

  • Gradual titration helps minimize side effects

  • Reconstitute to a practical concentration for accurate dosing

  • Storage: Lyophilized: store at room temperature in a dark spot or in its box; after reconstitution, refrigerate at 2–8 °C (35.6–46.4 °F). Avoid repeated freeze–thaw cycles.

Dosing & Reconstitution Guide

Standard / Gradual Approach (3 mL = ~1,667 mcg/mL)

Weeks

Daily Dose (mcg per injection)

Approx. Units (mL)

Weeks 1–4

300 mcg (1× daily)

18 units (0.18 mL)

Weeks 5–8

400 mcg (1× daily)

24 units (0.24 mL)

Weeks 9–12

500 mcg (1× daily)

30 units (0.30 mL)

Reconstitute the 5mg vial with 3 mL of bacteriostatic water, yielding ~1,667 mcg per mL. This keeps dosage units comfortably above 10 for most injections.

  • Draw 3.0 mL of bacteriostatic water with a sterile syringe.

  • Inject the water slowly into the vial, aiming against the vial wall to avoid foaming.

  • Gently swirl or roll the vial until the powder fully dissolves (do not shake vigorously).

  • Refrigerate at 2–8 °C (35.6–46.4 °F), protected from light.

Advanced Approach (3 mL = ~1,667 mcg/mL)

Weeks

Daily Dose (mcg per injection)

Approx. Units (mL)

Weeks 1–4

300 mcg (2× daily)

18 units (0.18 mL)

Weeks 5–8

400 mcg (2× daily)

24 units (0.24 mL)

Weeks 9–12

500 mcg (2× daily)

30 units (0.30 mL)

Multiple daily injections may further stimulate GH release but also increase total usage per cycle. Reconstitute with 3 mL of bacteriostatic water for ~1,667 mcg/mL.

  • Draw 3.0 mL of bacteriostatic water with a sterile syringe.

  • Inject the water slowly into the vial, aiming against the vial wall to avoid foaming.

  • Gently swirl or roll the vial until the powder fully dissolves (do not shake vigorously).

  • Refrigerate at 2–8 °C (35.6–46.4 °F), protected from light.

Supplies Needed

Plan based on an 8 week daily protocol with gradual titration.

  • Peptide Vials:
    • 8 wks ≈ 2–4 vials
    • 12 wks ≈ 3–6 vials
    (More if planning higher doses or multiple daily injections)


  • Insulin Syringes:
    • 8 wks ≈ 8–16
    • 12 wks ≈ 12–24


  • Bacteriostatic Water (1*30 mL bottle): Use ~3.0 mL per vial for reconstitution.


  • Alcohol Swabs: One for vial stopper + one for skin per injection.

    • Per week: 14 swabs

    • 8 weeks: 112 swabs total

Protocol Overview

Concise summary of the once‑daily regimen.

  • Goal: Support growth hormone release for muscle, recovery, and wellness

  • Schedule: Daily subcutaneous injections for 8–12 weeks

  • Dose Range: 300-500 mcg per day

  • Reconstitution: Use ~3 mL for ease of measuring (~1.667 mg/mL)

  • Storage: Lyophilized vials frozen; reconstituted solution refrigerated; avoid refreezing.

Dosing Protocol

Suggested once-weekly injection approach for effective titration.

  • Weekly Dose: Start at 300 mcg once daily

  • Frequency: Daily but can be increased to 2× daily

  • Cycle Length: 8–12 weeks (longer cycles may be considered for advanced users)

  • Maximum Dose: Titrate dosage if well tolerated up to ~500 mcg per injection, based on personal response

  • Timing: Typically in a fasted state (morning or before bedtime)

‼️ Important Notes

Practical considerations for consistency and safety.

  • Use a new sterile insulin syringe for each injection and dispose of needles in a proper sharps container.

  • Rotate injection sites (abdomen, thigh, upper arm) to minimize local irritation or tissue changes over time.

  • Inject slowly and steadily; after injection, wait a few seconds before withdrawing the needle to prevent leakage.

  • Track progress throughout the protocol, adjusting dosage as recommended.

General subcutaneous injection guidance (for educational purposes).

  • Clean the vial’s rubber stopper and your chosen injection site with alcohol swabs; let them air-dry.

  • Using an insulin syringe, pinch a fold of skin and insert the needle at a 45–90° angle into the subcutaneous tissue (fat layer).

  • Do not aspirate (no need to pull back on the plunger) for subcutaneous injections. Inject the peptide slowly and steadily.

  • After injection, dispose of the syringe safely. Rotate injection sites (abdomen, thighs, upper arms) to prevent irritation or scar tissue build-up.

Potential Benefits & Side Effects

Ipamorelin is a selective growth hormone secretagogue that supports increased GH release.

  • GH Stimulation: Encourages the pituitary to secrete growth hormone

  • Selective Action: Minimal effect on cortisol or prolactin levels

  • Potentially aids in muscle recovery, tissue repair, and overall vitality

While users may observe improvements in body composition and recovery, results vary.

  • Improved muscle repair and potential lean mass support

  • Better sleep quality and recovery

  • Possible mild side effects: injection-site irritation, headache, or increased appetite

  • Rarely, users may experience water retention or joint discomfort

Important Note

This content is intended for educational purposes only and is not medical advice, diagnosis, or treatment.

Legal Disclaimer

All products listed, sold, mentioned, acquired on or through this website are intended strictly for laboratory and research purposes only. They are not for human consumption, veterinary use, or any form of in vivo experimentation. These materials are provided solely for qualified individuals, institutions, and professionals engaged in legitimate scientific research and testing.

By accessing this website, making an inquiry, or placing an order, you acknowledge and agree that:

  1. You are a qualified researcher, scientist, or institutional representative with the appropriate knowledge and facilities to safely handle materials of this nature.

  2. You understand and accept that the products are not to be used for any other purposes, including but not limited to medical, diagnostic, therapeutic, or recreational use.

  3. You understand that the products supplied are not approved by the FDA, EMA, or any other regulatory authority for human or animal use.

  4. You will use all products solely in accordance with applicable laws, regulations, and safety standards, and will not resell, distribute, or otherwise make them available for any prohibited purpose.

  5. You assume full responsibility for compliance with all applicable laws, regulations, and safety procedures regarding the handling, storage, and use of research chemicals and peptides.

  6. By contacting, communicating with, or purchasing from this website, you confirm your compliance with these conditions and agree to be bound by all associated terms and conditions.

The site owner, operators and its affiliates shall not be held liable for any misuse, handling errors, or consequences arising from improper application of these materials.